Categories

Manufacturers

CALL FOR
DELIVERY TIME
Expert - SPE-1.3K-FA-NO-AT - Amplifier 1.5 KW without AT View larger

Online only

Expert - SPE-1.3K-FA-NO-AT - Amplifier 1.3 KW without AT

Expert-1.3K-FA-NO-AT

New product

NEW VERSION II

1.3KW transistor amplifier with full automatic transistors without integrated antenna coupler

Frequencies: 1.8 MHZ to 50 MHZ included

CAUTION DELIVERY TIME OFTEN LONG YOU INQUIRE: info {at} xbstelecom.fr

More details

Your current price:
2.965,00 €

2 965,00 €


Product not deliverable for the moment.

More info

A message from SPE to all customers:

I must explain you the reasons for the delays in deliveries of the amplifiers Expert models 1.3K-FA and Expert 1.5K-FA

The initial reason is the lack of some values ​​of the capacitors used in the filter unit, this is partly due to the modification to the filters carried out to be compliant with the new EU standards.

Unfortunately, the delivery time has increased to 24 weeks and I can only accept this situation.

This time, however, has not been lost because it has been exploited for many changes to both on the 1.3K-FA and on the 1.5K-FA of which the main ones are:

- Redesign of a new filter card.-
- Direct welding of the LDMOS on copper.
- Redesign of the RF transformer obtaining a notable lowering of the temperature and a greater bandwidth.
- Etc.

But the changes are so many so we decided to call them "Series II" as we did in the past with the Expert 1K-FA amplifier

Your customers will be really satisfied, believe me.
So be patient.

We're working in order to ship all the ordered Experts as soon as possible.
Apologies for the delays.

  • The smallest in its class.
    Built-in Power supply and Automatic Antenna Tuner.
    Dimension: L 28, H 12, P 38 cm (11.02” W,. 4.72” H, 14.96” D) (connectors included).
    Approx. weight without ATU is about 7.5 Kg.(16.5lbs).
  • The most technologically advanced in the world
    Two powerful CPUs are used.
    Over 30,000 lines of software, for performance that cannot be found in any other amplifier.
  • Fully Automatic
    Easy connection with all models "ICOM, YAESU, KENWOOD, TEN-TEC, FLEX-RADIO, ELECRAFT" for immediate management of the bands, tuner (version with Automatic Tuner) and antennas. 
    Same performance with all makes and some homemade rigs.
    The operator has to only move the “Frequency Tuning Knob” of the transceiver !!
  • Wide frequency coverage
    1.8 MHz to 50 MHz including WARCs.
    Where permitted 60 m. full power and 600 W typ. on 4 m. (70 MHz).
  • Fully solid state
    Up to 1.5 (1.3 typ.) KW pep SSB, CW out; 50 MHz included.
    MAX , MID (800 W) or LOW (450 W) power selected according to the operator’s SSB/CW power requirement, for digital modes and for linear protection (automatic).
    No warmup time, immediately ready!
    Virtually limitless life of the amplification device. Only one LD / MOSFET used.
  • Without ATU allowing significant savings.
  • SO2R
  • Two inputs available.
    SO239 connectors.
  • High power gain (up to 14.5 dB).
    In “OPERATE“ the required drive power is automatically set with the ALC connection. And in “STANDBY“ the exciter is automatically reset to full power.
  • Very clean and low distortion output!
    Spurious emissions FCC compliant.
    3rd order distortion (two tone test) from -30 to -35 dB typ.
  • Input 50 ohm always perfectly matched
    The same protection is realized in two different ways:
    · Via hardware circuits (HW) to assure great speed.
    · Via the software (SW), to assure great accuracy.
    Thanks to the sophisticated software, the transmit relay changeover is carried out with zero current on the contacts.
  • Full break-in operation (QSK)
  • Quiet operation.
    Linear management of the speed of the cooling fans of the heatsink.
    The amplifier develops a significant amount of heat that must be removed.
    Therefore, every precaution is used to keep the fan noise at the lowest possible level. Fan noise is significantly lower than with tube type amplifiers.
  • Continuous use
    “MAX” mode: SSB / CW unlimited.
    Automatically switches to “MID” if in “MAX” a continuous signal (RTTY) is transmitted for more than 15 sec.
    “MID” and “LOW” modes, RTTY unlimited.
  • Switching power supply.
    Continuously operable at inputs between 100 – 255 Vac, 47-63 Hz.
    (100-120 Vac may cause slightly reduced output power).
    PFC (Power Factor Correction).
  • The linear can be switched ON / OFF also switching ON / OFF the exciter.
  • Fully remotable.
  • With a large LCD display is possible to have a great deal of information
    Watts pep out, Vpa, Ipa, Watts, Power gain, Temperatures, SWR (after and before the ATU), Input setting, CAT setting, Band and other indications including the alarms log.
  • Easy to operate
    Powerful and sophisticated software gives you a user-friendly unit.
  • USB / RS232 ports
    For remote control.
    For new SW releases download.
  • Easy transportation
    A sturdy carry-bag is supplied for “QSY, FIELD DAY, DX’ PEDITIONS etc.“.
  • Certifications :
    CE, FCC.

N.B. Les prix et les spécifications sont sujets à changement(s) sans aucune notification ou délai de mise en vigueur.

Reviews

Write a review

Expert - SPE-1.3K-FA-NO-AT - Amplifier 1.3 KW without AT

Expert - SPE-1.3K-FA-NO-AT - Amplifier 1.3 KW without AT

NEW VERSION II

1.3KW transistor amplifier with full automatic transistors without integrated antenna coupler

Frequencies: 1.8 MHZ to 50 MHZ included

CAUTION DELIVERY TIME OFTEN LONG YOU INQUIRE: info {at} xbstelecom.fr

Accessories